Wulf Gaertner Autoparts has expanded its HD range for French car makes and models with the introduction of MEYLE-HD tie rod ends with a longer service life thanks to a larger ball pin.

Recognising that the tie rod end was an easy-wearing component on many Peugeot and Citroen models, Wulf Gaertner Autoparts engineers have redesigned the part which now features a larger ball head diameter to reduce overall surface pressure. This, in combination with high-grade low-wear materials, significantly increases the part life.

Peugeot and Citroen drivers sometime complain about excessive noise and play in the steering. In most cases, unresponsive vehicle handling is due to prematurely worn out tie rod ends.

To increase tie rod end life Wulf Gaertner Autoparts has engineered HD tie rod end assemblies to fit Peugeot and Citroen models, marketed under the part numbers 1-16 020 5703 HD, 40-16 020 5724 HD und 40-16 020 5723 HD. Compared to the original-equipment design the ball head diameter of the technically enhanced MEYLE-HD part has been increased by 3mm to now measure 25mm, allowing the effective loads to be distributed across an approx. 25% larger surface area and significantly reducing surface pressure on the ball joint's plastic socket.

The joint is made of special materials to minimise wear, while wear-reducing lubricating additives added to the high-tech grease help prevent in-part corrosion. These technical refinements ensure that MEYLE-HD tie rod end assemblies will outlast original equipment spares.

MEYLE products and distributed by Strongline Autoparts and available from factors nationwide. For more information call (01)-0462-04631.